In general, the switches and router sub-interfaces cooperate. Because the switch is a Layer 2 switch and there is no Layer 3 routing function, the Layer 3 exchange is transparently transmitted through the router to implement Layer 3 interworking. This is the main reason for this type of networking. purpose. Between router sub-interfaces, each network segment is a direct route. If you want to achieve access control between certain network segments, you usually configure the access control list on the router.
S5700 SI Series Gigabit Enterprise Switches CNET Content Trunk configuration of the port: Configuration environment parameters: 1. SW1 port Ethernet 0/0/1 belongs to VLAN 10, Ethernet 0/0/2 belongs to VLAN 20, Gigabitethernet0/0/1 and R1 port Gigabitethernet0/0/0 are interconnected; 2. Vlan10 The internal PC address is 192.168.0.2/24, and the gateway is the subinterface address of the router Gigabitethernet0/0/0.1 192.168.0.1/24.
Huawei 24 Ports Switch Price Router Switch 3. The internal PC address of the Vlan20 is 10.10.10.2/24. The gateway is the address of the subinterface Gigabitethernet0/0/0.2 of the router, 10.10.10.1/24. 4. The SW1 manages the virtual interface address of the VLAN100 and the gateway is GigabitEthernet0/0/172.16.0.2/24. 0 interface address 172.16.0.1/24.
All hot new air switch and the performance of the full heat new wind switch Networking requirements: 1. Vlan10, Vlan20, and Vlan100 can be transparently transmitted to routers through switches, and can implement Layer 3 interworking through router sub-interfaces; 2. Data configuration steps.
Hardware firewall settings, complex set of simple operations