=12px[color=#000000]For the customers, the sand making machine equipment that they hope to buy can always be produced efficiently, but any equipment is not idealized. We have talked about some ways to use the sand making machine efficiently to improve efficiency. Let's talk about the correct use of the
sand making machine to reduce power consumption, so as to improve the service life of the equipment.[/color]=12px[color=#000000]First of all, we should understand a problem, the new sand making machine is the third process of the entire sandstone production line, one is feeding, the second is the rough breaking of the jaw crusher, and the third is the new sand making machine. The new sand making machine is used as a rough breaking equipment in the crushing of hard materials such as ore. It has the characteristics of large crushing ratio, high output, uniform particle size, simple structure, convenient maintenance and low production cost. When the new sand making machine works, the moving jaws are in direct contact with the materials, and thus the load is often large. There are insurance pieces to provide protection for this situation, which will greatly improve the active control ability of all sand making equipment and production lines. Secondly, we should understand that the more mud or fine grain in the feed of the gravel production line, the greater the viscosity of the slurry, the smaller the sedimentation velocity of the ore in the slurry, and the coarser the particle size of the overflow product; In case, in order to ensure the desired overflow fineness, the additional water can be appropriately increased to reduce the slurry concentration. If the amount of mud in the feed is small, or after de-sludge treatment, the concentration of the slurry should be appropriately increased to reduce the amount of fine-grained materials entrained in the return sand.[/color]=12px[color=#000000]When the new sand making machine enters the non-crushing stone in the crushing chamber, the rear thrust plate is taken as the safety component of the
sand making machine to protect the important parts of the equipment from damage. The back thrust plates are individually cast from cast iron, and a slot or holes are opened therein to reduce the strength of the section; or two pieces can be cast, and then screwed together to form a combined thrust plate. However, when the stone that cannot be crushed and sand enters the fine crushing cavity, the equipment generates an overload scene, and the thrust plate is transmitted to the thrust plate to cause the thrust plate to be broken or the screw of the combined thrust plate to be cut, and the machine ends the work to play an insurance role. This design principle is not only very suitable, but also easy to hold, the use of insurance parts is cheap, easy to operate, and the overall maintenance and damage of the equipment is also very good.[/color]=12px[color=#000000]The new sand making machine has fine grain requirements for sand making materials. In general, the needle-like material enters the finely divided nacelle, and the requirements for the crushed stone are contrary to the above, and the requirements for the grain type and the grain size are very strict. The reason is that the cubic sand has a function of locking each other due to its angular shape, and the continuous grading of the sand can greatly reduce the void, while the cubic sand occupies a larger surface area than the circular sand. Sticking asphalt and materials or cement and materials together reduces the possibility of displacement.[/color]=12px[color=#000000]In this respect, users may feel that the loss of the new sand making machine seems to be more difficult than improving production efficiency, but it is not. This is just a matter of literal understanding. As long as we usually produce and observe more research, we will understand that the new sand making machine is a sand making device with a very simple working principle. It is simpler and more efficient than traditional equipment. More to bring benefits to customers. If you have any technical questions, please feel free to call our company's sanding equipment sales department. Our company will provide you with a professional answer free of charge.[/color]