During the production and use of
vertical roller mill, the circulation air duct will be blocked. Here,ZENITH reminds everyone to stop the material in time and check the cause of blockage of the air duct. After the inspection, the material can be ground. Powder production. What are the reasons for the blockage of the air duct, the following is a brief introduction.
Too much or too little material will cause the vertical roller mill to be insufficiently ground. The finished powder can not be discharged in the circulation duct under the action of the blower in time, thus increasing the working load of the blower, causing the material to accumulate in the air duct, eventually leading to the air duct.
Blocked. Therefore, when feeding the vertical roller mill, ensure that the material is continuously and evenly distributed to avoid the phenomenon of air passage blockage.